Switching 11

[ Up ] [ Switching 1 ] [ Switching 2 ] [ Switching 3 ] [ Switching 4 ] [ Switching 5 ] [ Switching 6 ] [ Switching 9 ] [ Switching 10 ] [ Switching 11 ] [ Switching 12 ] [ Switching 14 ] [ Switching 17 ] [ Switching 18 ] [ Switching 21 ] [ Switching 23 ] [ Switching 25 ] [ Switching 26 ] [ Switching 29 ]

[ Back ] [ Next ]

SWITCHING

EXCELLENT

~~~

SIGN | VIEW
GUESTBOOK

11. Configure a switch to participate in multiplayer switching

Enable multilayer switching to cooperate with input access lists
router(config)#mls rp ip input-acl

MLS is enabled by default on the Catalyst Series Switches that support Layer 3 switching. If the MLS-RP is the RSM, RSFC, MSFC, or MSFC II, no configuration is needed for the switch for which the MLS-RP resides. Configuring the switch is necessary when the following are true:

The MLS-RP is an external router.
The aging time for MLS cache entries is other than the default.

If a switch has been disabled for Layer 3 switching, enter the following command in privileged EXEC mode on the switch.

Switch> (enable) set mls enable

Adding external router MLS identification
Switch> (enable) set mls include ip-addr

Verify MLS configuration
Switch> (enable) show mls

This Website is not sponsored by, endorsed by or affiliated with Cisco Systems, Inc. Cisco®, Cisco Systems®, CCDA™, CCNA™, CCDP™, CCNP™, CCIE™, CCSI™, the Cisco Systems logo and the CCIE logo are trademarks or registered trademarks of Cisco Systems, Inc. in the United States and certain other countries. All other trademarks are trademarks of their respective owners. Opinions expressed on this site are solely those of the participants and may not reflect the opinions of the owners or moderators of this site.