 |
This page is best viewed with browser setting at 800x600 fully maximized & with 32-bit True color.
|
 |
Rope Harness Instructions
by Ropeman.
Used here with permission.
Applying the Rope Harness
The following group of (graphic - nude) pictures will give you some idea of the process in applying the Rope Harness
The pictures are rather time consuming to load. I think you will find them worth the wait! Take the time being used to load them by tying each step on someone "close"
If male nudity and bondage offend you, don't continue past this message.
Press the BACK key to return to the most previous viewed page.
I will continue to update this page with text instructions as time permits.
Remember, practice makes perfect.
(Also remember to stay SAFE and have FUN!)
The Ropeman has commanded !
The "Rope Harness" which is pictured here has actually been around for a long time. Many variations of it can be seen throughout pictures and drawings in many bondage magazines and leather publications. I came across the design in Drummer Magazine #105 about 2 years ago and began attempting to tie it on myself (a very strange sight to watch!). Finally, last year at The River's Edge (an alternative lifestyles campground in Dewy Rose, Georgia) I found several VERY willing souls to "experiment" on.
Step 1 in the process is to determine the center point of a piece of rope 35' to 100' long, depending on what you want to do with the subject. The shorter the rope the easier it is to deal with. Try the 35' length until you get the hang of it, then add more length and become more creative later. This black piece is 75 feet.
At the halfway point in its length, tie an overhand knot making a loop 3 or 4 inches long and place the rope over the subjects head with the loop at the level of the shoulder blade.
Keep the knot in place and tie another overhand knot at a point on the subject's chest equal to the spot which corresponds to the bottom of the loop at the shoulder blades.
Drop down several inches (depending on the size of the subject) and tie another overhand knot.
At a point about half way between the belly button and the shaft of his cock, tie another overhand knot.
You now have a loop in the back and three knots down the front of the subject.
The next knot is a FUN ONE! Run the two strands of rope to either side of the subject's balls and up the crack of his ass. Holding the rope in one hand, locate the subject's asshole with your finger adjacent to the rope. Mark the spot and remove the rope from his crotch.
Tie one (or two or more) overhand knots at this point. Make sure not to loose the marked position. Once done. Replace the rope around the balls and up the ass crack. Locate the knot(s) and the asshole.
Position the knot at EXACTLY at that spot!
This SPECIAL knot has many uses. The one I think it was designed for, is to hold a Butt Plug in place. It does that very nicely too! It also allows the subject to "Feel" the knot without a Butt Plug in place, every time he walks, moves or sits.
Now run the entire rope up the subject's back and through the loop at his shoulder blades. Pull it through completely. Be careful at this point not to pull to tight. Not because of the knot in his ass but because the rope going over the shoulders becomes tighter as the harness is being built. At the end of the construction it can become unbearable (for some) and has to be removed to be loosened.
Now pull each end of the rope to the front of the subject from each side. loop it in between the two top knots and pull completely through and back around each side to the back of the subject again.
At the subject's back, loop the rope under the vertical strand of rope and back to the front again.
This time loop the rope, from each side, between the two knots at the belly button and pull through completely.
You should now have two "diamonds" of rope down the front of your subject and a loop, a large diamond and a knot in his ass, in back.
The next portion is a little tricky. Bring each end of the rope from the belly button diamond to the "Y" of your subject's butt. Thread behind and back toward the front of each side of the "Y". What this should do when you put tension from right and left, is to separate the rope at the "Y" acting somewhat like a spring. Separate from right to left far enough to permit the rope to cross one another. This separation will create another diamond.
Wrap around the sides of your subject once again and thread through the opening between the shaft of his dick and the knot just below his belly button. Thread this completely through.
Wrap the ends around the sides of his thighs (following the natural lines of his butt cheeks) and then between his legs, up on either side of his cock and balls. Wrap several times around them and tie a square knot above at the base of the shaft (or below his balls to lift and emphasize them more!)
There's more to come! Enjoy these for now...
And Finally (for now 9/27/97) YES, the harness IS multi-functional!!
Remember to play safe
Check your subjects hands, feet, arms, fingers, etc for lack of circulation
A sure sign that circulation is restricted is if the area is cool to the touch or turning blue (DUU-UUH!)
Bondage can be fun and sensual for all concerned if it's done right
If it's not fun for both partys - Something is wrong
If I can help, you can e-mail me at: 
Who is this Ropeman guy anyway?
* (BRC note: Ropeman's link to his page above is best viewed with IE and not Netscape) *
Bound & Gagged
Home - top of page - Back - E-mail CC - Articles TOC - Next
Mirror site: http://www.thebrc.net/
Support the BRC ~ and shop Amazon.com here or thru the box below!
Sign The Guestbook 
View The Guestbook
Sign The Dreambook 
Read The Dreambook
Home - top of page - Back - E-mail CC
Web page design and content by ~Cyberotica-Chrysalis~
Some graphics and HTML help from Cheryl at Cinn's Creations and Elf.
Original HTML help from Redline Designs.
Copyright © - 1998-2000.
Updated as of 24 September 2000.