@DréCB/10MIR000=27.805Mhz./USB&6635Khz./LSB@   

MODIFICATIE  INFO

ALINCO  DJ - 446

PMR  TRANSCEIVER

Frequency range	:	446.00625-446.09375 MHz (All PMR-446 channels) 
RF Power output	:	Max 0.5 W 
Voltage		:	9.6 VDC (NiMH) 
Current drain		:	RX: Max ? mA
TX			:	Max ? mA 
Dimensions (W*H*D):	? mm 
Weight		:	? gr 
Manufactured		:	2001-200x 
Other			:	CTCSS 
Extras			: 

Alinco DJ-446

FREQUENCY-  or  CHANNEL in DISPLAY

To change the display from FREQ. to CHANNEL numbers, there is a shuntable resistance R213

found on the main PCB behind a metal plate. 

First open the radio and unscrew the main PCB.

Gently turn over the main PCB and DESOLDER the metal plate on the bottom of the PCB. 

You can PROGRAM the FREQUENCIES in the FREQ.-DISPLAY MODE, then remove the shunt to

pass on CHANNEL-DISPLAY. 

Alinco DJ-446

POWER OUTPUT MODIFICATION from default 500mw to 5 Watts

Remove the antenna/MIC/Sp cover rubber and mail dial.

No tool is required but just carefully pull them out.

With slightly enlarging the bottom of the front plastic case toward outside by hand,

take the metal main chassis out of the case.

No screw is used.

Be careful;

the chassis and the case is connected with a speaker cable harness.

There is a small connector at the left side of LCD.

Remove it before you completely separate the unit.

On the main unit circuit board, just below the antenna there is a screw

and there is another one just about 2cm below.

Between the screw and a black square component, there is a blank terminal

without any component soldered.

Solder this terminal (close circuit).

Reassemble the unit. No CPU reset is necessary.

    @DréCB/10MIR000=27.805Mhz./USB&6635Khz./LSB@