|
|
These network cabinets function as distribution centers to locations in their vicinity. Each is directly connected back to the main network cabinet in the Computer and Telecommunications Room.
The network and phone cables travel down to the offices within the four-inch conduit. Network drops were required at various point throughout the manufacturing area. These drop came back to this cabinet (from drops within an 80m radius). Phone trunk lines connected this cabinet back to the main Computer and Telecommunications Room. Phone and modem BIX blocks were mounted on the back wall within the cabinet.
Both
cabinets were lockable, and had double hinges. In addition to normal
access to the front, you could swing the entire stack of rack mounted equipment
out. This enabled us to mount the phone and modem BIX blocks on the rear
inside wall, and to access the back of the switches. Copper link lines between these remote cabinets provided a Standby Link. Under normal network operating conditions, the Main Link (the fibreoptic cables) carries the data. If a signal loss is detected, the Switch immediately enables the standby port so that it carries the data. (The main port is then disabled.) See the Network Plans page for a diagram.
|
Questions or comments? Enter your comments on our Feedback Form Or send mail to paul@PaulAcacia.com or to pacacia@mail.com. Copyright©2000 P. Acacia Consulting Last modified: Monday, May 08, 2000
|